Difference between revisions of "Slic3r"

From MatterControl Manual
Jump to: navigation, search
Line 1: Line 1:
'''Slic3r''' is a third-party slicing engine which has been integrated into MatterControl. It was created in 2011 by members of the RepRap community.
+
'''Slic3r''' is a third-party slicing engine which has been integrated into MatterControl.  
 +
 
 +
== Origin ==
 +
 
 +
Slic3r was created in 2011 by members of the RepRap community.<ref>[http://reprap.org/wiki/Slic3r Slic3r - RepRapWiki]</ref>
 +
 
 +
== Documentation ==
  
 
The complete list of available Slic3r slice settings for use in MatterControl can be found on the [[Slic3r Settings]] page.
 
The complete list of available Slic3r slice settings for use in MatterControl can be found on the [[Slic3r Settings]] page.
 +
 +
== Repository ==
 +
 +
Slic3r is an open source project hosted on GitHub: https://github.com/alexrj/Slic3r
 +
 +
== References ==
 +
 +
<references />
  
 
[[Category:Slice Engines]]
 
[[Category:Slice Engines]]
[[Category:Incomplete]]
 

Revision as of 17:22, 11 February 2016

Slic3r is a third-party slicing engine which has been integrated into MatterControl.

Origin

Slic3r was created in 2011 by members of the RepRap community.[1]

Documentation

The complete list of available Slic3r slice settings for use in MatterControl can be found on the Slic3r Settings page.

Repository

Slic3r is an open source project hosted on GitHub: https://github.com/alexrj/Slic3r

References

  1. Slic3r - RepRapWiki