Changes

Configuring Print Leveling

823 bytes added, 19:32, 4 December 2015
Created page with "'''Getting the bed set up if the z switch is on the bottom (z-min)''' The goal of this process is to get the z-home position to be just touching the bed perfectly, then get t..."
'''Getting the bed set up if the z switch is on the bottom (z-min)'''

The goal of this process is to get the z-home position to be just touching the bed perfectly, then get the other parts of the bed to be just a bit higher.

#Home the printer on all axis
#Adjust the z-limit height (should be one on most every printer) until the extruder is just touching the bed when homed
#Release the motors so you can move the extruder around the bed
#Raise the extruder 1 mm in z
#Move the extruder to the other 3 points of the bed (not the x y home position)
#Mechanically raise the bed so that it is just touching the extruder at these other 3 positions.
#Your bed should now be at a very slight angle with the lowest point being in the home position.

Your bed should now be in a great state for automatic print leveling to work.