2,552
edits
Changes
Created page with "In MatterControl there are several files that are used to configure SliceSettings *'''StaticDataPrinterSettingsconfig.ini''' - This is the list of all possible printer settin..."
In MatterControl there are several files that are used to configure SliceSettings
*'''StaticDataPrinterSettingsconfig.ini''' - This is the list of all possible printer settings. Your new type needs to be in here.
*'''StaticDataSliceSettingsLayouts.txt''' - This file describes where the setting will be laid out in the ui.
*'''StaticDataSliceSettingsProperties.txt''' - This file contains the description of the friendly name and the help for each setting.
== How to add a new setting ==
#Add the setting name to config.ini
#Put the setting name in the right place in Layouts.txt
#Add the friendly name and help text to Properties.txt
If the setting is also applicable to CuraEngine you need to write some code.
#Open - SlicerConfigurationSlicerMappingEngineMappingCura.cs
#Add the setting to curaToDefaultMapping. Write translation code if required
If the setting should not be available in Slic3r
#Open - SlicerConfigurationSlicerMappingEngineMappingSlic3r.cs
#Add the setting name to hideItems
[[Category:Development]]
*'''StaticDataPrinterSettingsconfig.ini''' - This is the list of all possible printer settings. Your new type needs to be in here.
*'''StaticDataSliceSettingsLayouts.txt''' - This file describes where the setting will be laid out in the ui.
*'''StaticDataSliceSettingsProperties.txt''' - This file contains the description of the friendly name and the help for each setting.
== How to add a new setting ==
#Add the setting name to config.ini
#Put the setting name in the right place in Layouts.txt
#Add the friendly name and help text to Properties.txt
If the setting is also applicable to CuraEngine you need to write some code.
#Open - SlicerConfigurationSlicerMappingEngineMappingCura.cs
#Add the setting to curaToDefaultMapping. Write translation code if required
If the setting should not be available in Slic3r
#Open - SlicerConfigurationSlicerMappingEngineMappingSlic3r.cs
#Add the setting name to hideItems
[[Category:Development]]
