2,552
edits
Changes
Created page with "{{Slice Settings |The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.|Millimeters| === mm === On the right half of th..."
{{Slice Settings
|The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.|Millimeters|
=== mm ===
On the right half of this screenshot, the three lines on the left are the perimeters, and the diagonal lines on the right are the infill. The infill overlaps just 0.06 mm, which is usually enough to ensure that the infill will stick to the inside-most perimeter.}}
|The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.|Millimeters|
=== mm ===
On the right half of this screenshot, the three lines on the left are the perimeters, and the diagonal lines on the right are the infill. The infill overlaps just 0.06 mm, which is usually enough to ensure that the infill will stick to the inside-most perimeter.}}
