Search results
Create the page "Slice Settings/Filament/Filament/Retraction/Wipe After Retract" on this wiki! See also the search results found.
- ** Support for custom wipe tower shapes *Added filament selection into leveling wizard so we heat to printing temp before sampling.25 KB (3,207 words) - 15:22, 7 June 2019
- The slice settings for Slic3r in MatterControl are divided by three categories: * '''General''': This is where the settings concerning the actual printed part are located. Things like, layer height,16 KB (2,499 words) - 13:04, 22 December 2016