Difference between revisions of "SETTINGS/General/Multiple Extruders/Extruder Change/Wipe Tower Size"
From MatterControl Manual
< SETTINGS | General | Multiple Extruders | Extruder Change
(Created page with "{{Slice Settings |The length and width of a tower created at the back left of the print used for wiping the next nozzle when changing between multiple extruders. Set to 0 to...") |
(No difference)
|
Revision as of 17:33, 22 December 2015
Function
The length and width of a tower created at the back left of the print used for wiping the next nozzle when changing between multiple extruders. Set to 0 to disable.
Parameters
- millimeters (mm)
Example(s)
mm
For this example, Calibration - Box.stl is the model used.
A 2 mm x 2 mm wipe tower shown at the back left of the two Calibration Boxes.
