Difference between revisions of "Custom G-Code Variables"
From MatterControl Manual
Line 1: | Line 1: | ||
− | MatterSlice allows you to place certain tokens in your [[Slice Settings/Printer/Custom G-Code|custom GCode]] that will automatically be replaced with the appropriate values. For example: | + | [[File:Lulzbot Mini Custom GCode Example.png|framed|right|<center>The Lulzbot Mini makes use of Custom GCode variables.</center>]]MatterSlice allows you to place certain tokens in your [[Slice Settings/Printer/Custom G-Code|custom GCode]] that will automatically be replaced with the appropriate values. For example: |
<code>M109 S[temperature]</code> | <code>M109 S[temperature]</code> |
Revision as of 17:19, 29 December 2015
MatterSlice allows you to place certain tokens in your custom GCode that will automatically be replaced with the appropriate values. For example:M109 S[temperature]
In this line, [temperature]
will be replaced with the extruder temperature defined in your slice settings. These tokens can be enclosed in either square brackets [] or curly brackets {}, but for compatibility with other slicers we recommend square brackets.
Here is the list of currently available tokens:
variable | Slice Settings Page |
---|---|
temperature | Extruder Temperature |
bed_temperature | Bed Temperature |
bed_remove_part_temperature | Bed Remove Part Temperature |
extruder_wipe_temperature | Extruder Wipe Temperature |
z_offset | Z Offset |
retract_length | Length on Move |
filament_diameter | Filament Diameter |
first_layer_speed | First Layer Speed |
infill_speed | Speed for Infill |
max_fan_speed | Maximum Fan Speed |
min_fan_speed | Minimum Fan Speed |
min_print_speed | Minimum Print Speed |
perimeter_speed | Inside Perimeter Speed |
retract_speed | Retraction Speed |
support_material_speed | Support Material Speed |
travel_speed | Travel Speed |
bridge_fan_speed | Bridging Fan Speed |
bridge_speed | Bridge Speed |
raft_print_speed | Raft Speed |
external_perimeter_speed | Outside Perimeter Speed |