Difference between revisions of "SETTINGS/Filament/Extrusion/Extrusion Width/Support Material"
From MatterControl Manual
< SETTINGS | Filament | Extrusion | Extrusion Width
(Created page with "{{Slice Settings |A modifier of the width of the extrusion when printing support material.|*millimeters (mm) *...") |
|||
| Line 8: | Line 8: | ||
=== mm === | === mm === | ||
| − | In this example, the adjusted nozzle diameter for the support material extrusion will be .3 mm.}} | + | In this example, the adjusted nozzle diameter for the support material extrusion will be 0.3 mm.}} |
=== % === | === % === | ||
Revision as of 12:04, 31 December 2015
Function
A modifier of the width of the extrusion when printing support material.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the support material extrusion will be 0.3 mm.
%
In this example, the nozzle size set under Printer settings will be modified by 115%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.46 mm.
