Difference between revisions of "SETTINGS/Printer/Custom G-Code/Start G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
(Redirected page to Start GCode) |
|||
| Line 1: | Line 1: | ||
| − | + | {{Slice Settings | |
| + | |||
| + | |G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.|*G-Code | ||
| + | |||
| + | Will accept [[Custom_G-Code_Variables|Custom G-Code variables]].| | ||
| + | |||
| + | === G-Code === | ||
| + | |||
| + | In this example, the printer will home (G28) at the beginning of the print.}} | ||
Revision as of 13:28, 13 January 2016
Function
G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
Parameters
- G-Code
Will accept Custom G-Code variables.
Example(s)
G-Code
In this example, the printer will home (G28) at the beginning of the print.
