Difference between revisions of "SETTINGS/Printer/Custom G-Code/End G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
(Created page with "{{Slice Settings |G-Code to be run at the end of all automatic output (the very end of the G-Code commands).|*G-Code Will accept Custom_G-Code_Variables|Custom G-Code vari...") |
(No difference)
|
Revision as of 13:32, 13 January 2016
Function
G-Code to be run at the end of all automatic output (the very end of the G-Code commands).
Parameters
- G-Code
Will accept Custom G-Code variables.
Example(s)
G-Code
In this example, the printer will home (G28) at the end of the print.
