Difference between revisions of "Custom G-Code Variables"

Revision as of 17:28, 28 January 2016 (view source) MatterHackers (Talk | contribs) (Tags: Mobile edit, Mobile web edit) ← Older edit		Revision as of 17:06, 2 February 2016 (view source) MatterHackers (Talk | contribs) Newer edit →
Line 51:		Line 51:
	| <tt>external_perimeter_speed</tt> || [[Settings/General/Speed/Speed for Perimeters/Outside Perimeter|Outside Perimeter Speed]]		| <tt>external_perimeter_speed</tt> || [[Settings/General/Speed/Speed for Perimeters/Outside Perimeter|Outside Perimeter Speed]]
	|}		|}
		+
		+	[[Category:Slice Settings]]

---

Revision as of 17:06, 2 February 2016

MatterSlice allows certain tokens to be placed in custom G-Code that will automatically be replaced with the appropriate values. For example:

M109 S[temperature]

In this line, [temperature] will be replaced with the extruder temperature defined in your slice settings. These tokens can be enclosed in either square brackets [] or curly brackets {}, but for compatibility with other slicers square brackets are recommended.

Here is the list of currently available tokens:

variable	Slice Settings Page
temperature	Extruder Temperature
bed_temperature	Bed Temperature
bed_remove_part_temperature	Bed Remove Part Temperature
extruder_wipe_temperature	Extruder Wipe Temperature
z_offset	Z Offset
retract_length	Length on Move
filament_diameter	Filament Diameter
first_layer_speed	First Layer Speed
infill_speed	Speed for Infill
max_fan_speed	Maximum Fan Speed
min_fan_speed	Minimum Fan Speed
min_print_speed	Minimum Print Speed
perimeter_speed	Inside Perimeter Speed
retract_speed	Retraction Speed
support_material_speed	Support Material Speed
travel_speed	Travel Speed
bridge_fan_speed	Bridging Fan Speed
bridge_speed	Bridge Speed
raft_print_speed	Raft Speed
external_perimeter_speed	Outside Perimeter Speed