Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Skirt
m (MatterHackers moved page Settings/General/Raft-Priming/Priming/Minimum Extrusion Length to SETTINGS/General/Raft-Priming/Priming/Minimum Extrusion Length) |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The minimum length of filament to use to draw the | + | |The minimum length of filament to use to draw the [[SETTINGS/General/Raft-Priming/Priming/Loops|priming loops]]. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value. This is the measurement of the filament going into the extruder, not the length of the loops being extruded. We recommend setting this to the length of your hot end's hot zone. For an E3D or similar hot end this will be about 15 mm|*millimeters (mm) |
Can be zero.| | Can be zero.| | ||
Revision as of 12:14, 18 January 2017
Function
The minimum length of filament to use to draw the priming loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value. This is the measurement of the filament going into the extruder, not the length of the loops being extruded. We recommend setting this to the length of your hot end's hot zone. For an E3D or similar hot end this will be about 15 mm
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
