Difference between revisions of "SETTINGS/Filament/Extrusion/Extrusion Width"
From MatterControl Manual
m (MatterHackers moved page Settings/Filament/Extrusion/Extrusion Width to SETTINGS/Filament/Extrusion/Extrusion Width) |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Slice Settings Subsection|the extrusion width at which certain parts of the print will print.}} | {{Slice Settings Subsection|the extrusion width at which certain parts of the print will print.}} | ||
| − | |||
Latest revision as of 12:37, 1 December 2016
Extrusion Width is a section of the Extrusion sub-category in Filament settings which deals with the extrusion width at which certain parts of the print will print.
Settings:
