Difference between revisions of "OPTIONS/EEProm"
(→Interface) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 17: | Line 17: | ||
== Interface == | == Interface == | ||
| + | |||
| + | === Reset to Factory Defaults === | ||
| + | |||
| + | This will reset all settings to your firmware's defaults. | ||
=== Save to EEProm === | === Save to EEProm === | ||
| Line 29: | Line 33: | ||
Export .ini files containing EEPROM configuration. Click this button to open the OS file saver. | Export .ini files containing EEPROM configuration. Click this button to open the OS file saver. | ||
| + | |||
| + | === Close === | ||
| + | |||
| + | Close without saving changes. | ||
[[Category:Features]] | [[Category:Features]] | ||
[[Category:Firmware]] | [[Category:Firmware]] | ||
Latest revision as of 14:21, 2 August 2017
MatterControl supports interacting with EEPROM as allowed by the firmware-- Marlin and Repetier only.
EEPROM stands for 'Electrically Erasable Programmable Read Only Memory' and can also be written, 'EEPROM'. EEPROM is memory on the printer's circuit board which stores a series of values for certain settings. These values usually relate to the specific printer's geometric, physical, and operative functions and statistics.
Firmware Support
MatterControl supports EEProm for only Marlin and Repetier firmwares.
- Marlin firmware EEProm documentation: https://github.com/MarlinFirmware/Marlin/wiki/EEPROM
- Repetier firmware EEProm documentation: http://www.repetier.com/documentation/repetier-firmware/rf-installation/
Example
For an example of how to use the EEProm window to adjust the printer's steps per mm, check out this page: Setting Steps per mm
Interface
Reset to Factory Defaults
This will reset all settings to your firmware's defaults.
Save to EEProm
Saves any applicable changes made using the interface to the EEPROM on the printer.
Import...
Import .ini files containing EEPROM configuration. Click this button to open the OS file chooser.
Export...
Export .ini files containing EEPROM configuration. Click this button to open the OS file saver.
Close
Close without saving changes.
