Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Skirt
m (MatterHackers moved page Settings/General/Skirt and Raft/Skirt/Minimum Extrusion Length to Settings/General/Raft-Priming/Skirt/Minimum Extrusion Length) |
m (MatterHackers moved page Settings/General/Raft-Priming/Skirt/Minimum Extrusion Length to Settings/General/Raft-Priming/Priming/Minimum Extrusion Length) |
(No difference)
| |
Revision as of 17:28, 14 November 2016
Function
The minimum length of filament to use drawing the skirt loops. Enough skirt loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a skirt is shorter than this value.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
