Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"

Revision as of 12:37, 1 December 2016

A screenshot of the Minimum Extrusion Length setting as seen in MatterControl's SETTINGS pane.

Function

The minimum length of filament to use to draw the priming loops loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value.

Parameters

• millimeters (mm)

Can be zero.

Example(s)

mm

In this example, at least 6 mm of filament will be extruded into the formation of the skirt.