Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"

Revision as of 12:55, 20 January 2016

A screenshot of the Minimum Extrusion Length setting as seen in MatterControl's SETTINGS pane.

Function

The minimum length of filament to use drawing the skirt loops. Enough skirt loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a skirt is shorter than this value.

Parameters

• millimeters (mm)

Can be zero.

Example(s)

mm

In this example, at least 6 mm of filament will be extruded into the formation of the skirt.