Difference between revisions of "SETTINGS/General/Raft-Priming/Skirt/Minimum Extrusion Length"
From MatterControl Manual
< SETTINGS | General | Raft-Priming | Skirt
m (MatterHackers moved page Settings/General/Raft-Priming/Skirt/Minimum Extrusion Length to Settings/General/Raft-Priming/Priming/Minimum Extrusion Length) |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The minimum length of filament to use | + | |The minimum length of filament to use to draw the priming loops [[Settings/General/Skirt_and_Raft/Skirt/Loops|loops]]. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value.|*millimeters (mm) |
Can be zero.| | Can be zero.| | ||
Revision as of 12:07, 17 November 2016
Function
The minimum length of filament to use to draw the priming loops loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
