Bed Remove Part Temperature

Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. This page is in the process of being migrated. It's new home will be matterhackers.com/mattercontrol/support/slice-settings/filament/advanced#bed-remove-part-temperature.

A screenshot of the Bed Remove Part Temperature setting as seen in MatterControl's SETTINGS pane.

Function

The temperature to which the bed will heat (or cool) in order to remove the part, as specified in Custom G-Code.

Used only by Custom G-Code fields as a Custom G-Code variable.

Restrictions

• Not shown if Has Heated Bed is disabled.

Parameters

• degrees Celsius

Custom G-Code Variable

bed_remove_part_temperature

Example(s)

degrees

In this example, the bed will cool to 55 degrees after the print as specified in the End G-Code field, assuming the variable is used.