Custom G-Code Variables
Revision as of 17:58, 23 December 2015 by MatterHackers (Talk | contribs) (Created page with "MatterSlice allows you to place certain tokens in your custom GCode that will automatically be replaced with the appropriate values. F...")
Revision as of 17:58, 23 December 2015 by MatterHackers (Talk | contribs) (Created page with "MatterSlice allows you to place certain tokens in your custom GCode that will automatically be replaced with the appropriate values. F...")
MatterSlice allows you to place certain tokens in your custom GCode that will automatically be replaced with the appropriate values. For example:
M109 S[temperature]
In this line, [temperature] will be replaced with the extruder temperature defined in your slice settings. These tokens can be enclosed in either square brackets [] or curly brackets {}, but for compatibility with other slicers we recommend square brackets.
Here is the list of currently available tokens:
| variable | Slice Settings Page |
|---|---|
| temperature | Extruder Temperature |
| bed_temperature | Bed Temperature |
| bed_remove_part_temperature | Example |
| extruder_wipe_temperature | Extruder Wipe Temperature |
| z_offset | Example |
| retract_length | Example |
| filament_diameter | Example |
| first_layer_speed | Example |
| infill_speed | Example |
| max_fan_speed | Example |
| min_fan_speed | Example |
| min_print_speed | Example |
| perimeter_speed | Example |
| retract_speed | Example |
| support_material_speed | Example |
| travel_speed | Example |
| bridge_fan_speed | Example |
| bridge_speed | Example |
| raft_print_speed | Example |
| external_perimeter_speed | Example |