Resume G-Code
< SETTINGS | Printer | Custom G-CodeRevision as of 13:54, 13 January 2016 by MatterHackers (Talk | contribs)
Revision as of 13:54, 13 January 2016 by MatterHackers (Talk | contribs)
Function
G-Code to be run when the print resumes after a pause.
Parameters
- G-Code
Will accept Custom G-Code variables.
Example(s)
G-Code
In this example, when the 'Resume' button is pressed, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z10 E-10 F12000), then set coordinates to absolute positioning again (G90).
