Extruder Change

< SETTINGS‎ | General‎ | Multiple Extruders

Revision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Multiple Extruders/Extruder Change to Settings/General/Multiple Extruders/Extruder Change without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 12:55, 20 January 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/General/Multiple Extruders/Extruder Change to Settings/General/Multiple Extruders/Extruder Change without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Extruder Change is a section of the Multiple Extruders sub-category in General settings which deals with options for functions to perform if the printer changes between Multiple Extruders.

The Extruder Change section.

Settings:

Last modified on 1 December 2016, at 12:37