Open main menu

End G-Code

< SETTINGS‎ | Printer‎ | Custom G-Code
Revision as of 09:27, 12 October 2016 by MatterHackers (Talk | contribs)

Revision as of 09:27, 12 October 2016 by MatterHackers (Talk | contribs)

A screenshot of the End G-Code setting as seen in MatterControl's SETTINGS pane.

Function

G-Code to be run at the end of all automatic output (the very end of the G-Code commands).

NOTE: All Custom G-Code is subject to filtering rules.

Parameters

All G-Code must be uppercase to function properly.

Example(s)

G-Code

In this example, the printer will home (G28) at the end of the print.

End G-Code-ss-ex.png
Last modified on 1 December 2016, at 12:37