Minimum Extrusion Length
< SETTINGS | General | Raft-Priming | SkirtRevision as of 12:07, 17 November 2016 by MatterHackers (Talk | contribs)
Revision as of 12:07, 17 November 2016 by MatterHackers (Talk | contribs)
Function
The minimum length of filament to use to draw the priming loops loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
