Minimum Extrusion Length
< SETTINGS | General | Raft-Priming | SkirtRevision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Raft-Priming/Priming/Minimum Extrusion Length to SETTINGS/General/Raft-Priming/Priming/Minimum Extrusion Length)
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Raft-Priming/Priming/Minimum Extrusion Length to SETTINGS/General/Raft-Priming/Priming/Minimum Extrusion Length)
Function
The minimum length of filament to use to draw the priming loops loops. Enough loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a loop is shorter than this value.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
