First Layer Speed
< SETTINGS | General | Speed | ModifiersRevision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Speed/Modifiers/First Layer Speed to SETTINGS/General/Speed/Modifiers/First Layer Speed)
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/General/Speed/Modifiers/First Layer Speed to SETTINGS/General/Speed/Modifiers/First Layer Speed)
Function
The speed at which the nozzle will move when printing the first layer. If expressed as a percentage the Infill speed is modified. This affects the first layer of the print as well as the first layer of the raft, if there is one.
Parameters
- millimeters per second (mm/s)
- percent [of Infill speed] (%)
Custom G-Code Variable
first_layer_speed
Example(s)
mm/s
In this example, the first layer will print at 20 mm/s.
%
In this example, the first layer will print at 35% of the Infill speed (which for this example is set at 40), so the final speed will be 14 mm/s.
