End G-Code
< SETTINGS | Printer | Custom G-CodeRevision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Printer/Custom G-Code/End G-Code to SETTINGS/Printer/Custom G-Code/End G-Code)
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Printer/Custom G-Code/End G-Code to SETTINGS/Printer/Custom G-Code/End G-Code)
Function
G-Code to be run at the end of all automatic output (the very end of the G-Code commands).
NOTE: All Custom G-Code is subject to filtering rules.
Parameters
- G-Code
- Custom G-Code variables
All G-Code must be uppercase to function properly.
Example(s)
G-Code
In this example, the printer will home (G28) at the end of the print.
