Bridging Fan Speed

< SETTINGS‎ | Filament‎ | Cooling‎ | Fan Speed

Revision as of 17:38, 6 December 2016 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 17:38, 6 December 2016 by MatterHackers (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

A screenshot of the Bridging Fan Speed setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which the layer-cooling fan will run when bridging, expressed as a percentage of full power.

Restrictions

Not shown if Has Fan is disabled.

Parameters

percent (%)

Can be zero.

Custom G-Code Variable

bridge_fan_speed

Example(s)

%

In this example, the layer-cooling fan will run at 50% of full power when creating a bridge.

Bridging Fan Speed-ss-ex.png

Last modified on 13 September 2018, at 17:01