Infill

< SETTINGS‎ | General‎ | Speed‎ | Speed for Infill

Revision as of 13:06, 12 September 2018 by Tanderson (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 13:06, 12 September 2018 by Tanderson (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/.
This page is in the process of being migrated. It's new home will be matterhackers.com/mattercontrol/support/slice-settings/speed/speed#infill.

A screenshot of the Infill setting as seen in MatterControl's SETTINGS pane.

Function

The speed at which infill will print.

Parameters

millimeters per second (mm/s)

Custom G-Code Variable

infill_speed

Example(s)

mm/s

In the case shown below, the infill will print at 40 mm/s.

Last modified on 12 September 2018, at 13:06