Extrusion Width

< SETTINGS‎ | Filament‎ | Extrusion

Revision as of 11:49, 18 December 2015 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/Filament/Filament/Extrusion Width to Slice Settings/Filament/Extrusion/Extrusion Width without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Revision as of 11:49, 18 December 2015 by MatterHackers (Talk | contribs) (MatterHackers moved page Slice Settings/Filament/Filament/Extrusion Width to Slice Settings/Filament/Extrusion/Extrusion Width without leaving a redirect)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Extrusion Width is a section of the Extrusion sub-category in Filament settings which deals with the extrusion width at which certain parts of the print are printed.

The Extrusion Width section.

Settings:

Last modified on 1 December 2016, at 12:37