Minimum Extrusion Length
< SETTINGS | General | Raft-Priming | SkirtRevision as of 16:20, 21 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The minimum length of filament to use drawing the skirt loops. Enough skirt loops will be drawn to use...")
Revision as of 16:20, 21 December 2015 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |The minimum length of filament to use drawing the skirt loops. Enough skirt loops will be drawn to use...")
Function
The minimum length of filament to use drawing the skirt loops. Enough skirt loops will be drawn to use this amount of filament, overriding the value set in Loops if the value in Loops will produce a skirt is shorter than the Minimum Extrusion Length.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
In this example, at least 6 mm of filament will be extruded into the formation of the skirt.
