G-Code Terminal

The G-Code Terminal is a console window which shows input and output and can be used to directly issue G-Code commands to a connected printer.

It is accessed by clicking the icon in the Options menu under Hardware.

If checked, this function filters the text of the Readout Display of any automatically updated temperature output. Lines beginning with the following are omitted from display:

• <-wait
• <-ok
• ->M105
• <-T

Note: The M105 command and any response will be filtered even if the command is entered manually. To see this, uncheck Filter Output.

If checked, this function automatically capitalizes any text entered in the Input Field before it is sent to the printer.

Typically, printers only accept uppercase G-Code, so this can be useful if the user does not wish to type in caps or by using the shift key.

Note: Text still appears as lowercase in the Input Field; the capitalization occurs after the user sends the command but before it is sent to the printer.

The main part of the G-Code Terminal window is the large area in the middle where the input and output to and from the printer can be seen. This area scrolls down automatically as new text appears at the bottom, and previous text can be accessed by manually scrolling with the scroll bar on the right side.

In the example to the right, the Readout Display shows several lines of communication between MatterControl and the Rostock MAX V2 printer upon connection.

->

The -> symbol at the beginning of a line indicates that the line is being sent from MatterControl to the printer.

<-

The <- symbol at the beginning of a line indicates that the line is output from the printer.

A text input field in which the user enters G-Code commands to be sent to the printer. You can press the up arrow key to repeat the last command that was typed in.

This button sends any text in the Input Field to the printer.

This button clears the Readout Display of any text.

This button opens the operating system's file save window so the user can save a text file of the entire contents of the Readout Display.

This function can be useful for troubleshooting, and is commonly requested by MatterControl tech support.

This button closes the window.