Before Tool Change G-Code
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
Revision as of 16:58, 22 November 2016 by MatterHackers (Talk | contribs) (Created page with "{{Slice Settings |G-Code to be run before every tool change (T0, T1, T2, etc.). '''NOTE:''' All Custom G-Code is subject to filtering rules.|*G-Code *...")
Function
G-Code to be run before every tool change (T0, T1, T2, etc.).
NOTE: All Custom G-Code is subject to filtering rules.
Parameters
- G-Code
- Custom G-Code variables
All G-Code must be uppercase to function properly.
Example(s)
G-Code
In this example, the printer will retract 5 mm of filament before every tool change.
