Support Material
From MatterControl Manual
< SETTINGS | Filament | Extrusion | Extrusion Width
Revision as of 12:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Filament/Extrusion/Extrusion Width/Support Material to SETTINGS/Filament/Extrusion/Extrusion Width/Support Material)
Function
A modifier of the width of the extrusion when printing support material.
Parameters
- millimeters (mm)
- percent (%)
Set to 0 to use default extrusion width.
Example(s)
mm
In this example, the adjusted nozzle diameter for the support material extrusion will be 0.3 mm.
%
In this example, the nozzle size set under Printer settings will be modified by 115%. For this example, the nozzle size was 0.4 mm, so the adjusted size will be 0.46 mm.
