Difference between revisions of "SETTINGS/Filament/Cooling/Fan Speed/Bridging Fan Speed"
From MatterControl Manual
m (MatterHackers moved page Settings/Filament/Cooling/Fan Speed/Bridging Fan Speed to SETTINGS/Filament/Cooling/Fan Speed/Bridging Fan Speed) |
|||
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |The speed at which the [[layer-cooling fan]] will run when [[bridging]], expressed as a percentage of full power.|*percent (%) | + | |The speed at which the [[layer-cooling fan]] will run when [[bridging]], expressed as a percentage of full power. |
| + | |||
| + | === Restrictions === | ||
| + | |||
| + | *Not shown if [[SETTINGS/Printer/Features/Hardware/Has Fan|Has Fan]] is disabled.|*percent (%) | ||
Can be zero. | Can be zero. | ||
Revision as of 18:38, 6 December 2016
Function
The speed at which the layer-cooling fan will run when bridging, expressed as a percentage of full power.
Restrictions
- Not shown if Has Fan is disabled.
Parameters
- percent (%)
Can be zero.
Custom G-Code Variable
bridge_fan_speed
Example(s)
%
In this example, the layer-cooling fan will run at 50% of full power when creating a bridge.
