Difference between revisions of "SETTINGS/Printer/Custom G-Code/End G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |G-Code to be run at the end of all automatic output (the very end of the G-Code commands).|*G-Code | + | |G-Code to be run at the end of all automatic output (the very end of the G-Code commands). |
| + | |||
| + | '''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*G-Code | ||
*[[Custom_G-Code_Variables|Custom G-Code variables]] | *[[Custom_G-Code_Variables|Custom G-Code variables]] | ||
Revision as of 10:27, 12 October 2016
Function
G-Code to be run at the end of all automatic output (the very end of the G-Code commands).
NOTE: All Custom G-Code is subject to filtering rules.
Parameters
- G-Code
- Custom G-Code variables
All G-Code must be uppercase to function properly.
Example(s)
G-Code
In this example, the printer will home (G28) at the end of the print.
