Resume G-Code

From MatterControl Manual
< SETTINGS‎ | Printer‎ | Custom G-Code
Revision as of 13:37, 1 December 2016 by MatterHackers (Talk | contribs) (MatterHackers moved page Settings/Printer/Custom G-Code/Resume G-Code to SETTINGS/Printer/Custom G-Code/Resume G-Code)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
A screenshot of the Resume G-Code setting as seen in MatterControl's SETTINGS pane.


G-Code to be run when the print resumes after a pause.

NOTE: All Custom G-Code is subject to filtering rules.


All G-Code must be uppercase to function properly.



In this example, when the 'Resume' button is pressed after the print has been paused, the printer will set coordinates relative to the current position (G91), then move 10 mm down and extrude 10.8 mm of filament at a rate of 12,000 mm/minute (G1 Z-10 E10.8 F12000), then set coordinates to absolute positioning again (G90).

Resume G-Code-ss-ex.png