2,552
edits
Changes
m
MatterHackers moved page Settings/Printer/Custom G-Code/Start G-Code to SETTINGS/Printer/Custom G-Code/Start G-Code
{{Slice Settings |G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section. See also: [[CategoryAutomatic G-Code]] '''NOTE:Incomplete''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*[http://reprap.org/wiki/G-code G-Code]*[[Custom_G-Code_Variables|Custom G-Code variables]] All G-Code must be uppercase to function properly.| === G-Code === In this example, the printer will home (G28) at the beginning of the print.}} == See Also == *[[Automatic G-Code]]*[[G-Code Filtering]]