Start G-Code

From MatterControl Manual
Jump to: navigation, search
A screenshot of the Start G-Code setting as seen in MatterControl's SETTINGS pane.

Function

G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.

See also: Automatic G-Code

NOTE: All Custom G-Code is subject to filtering rules.

Parameters

All G-Code must be uppercase to function properly.

Example(s)

G-Code

In this example, the printer will home (G28) at the beginning of the print.

Start G-Code-ss-ex.png

See Also