Difference between revisions of "SETTINGS/Printer/Print Recovery/Recover Settings/XY Homing Position"
From MatterControl Manual
< SETTINGS | Printer | Print Recovery | Recover Settings
| Line 1: | Line 1: | ||
{{Slice Settings | {{Slice Settings | ||
| − | |Specify the X and Y coordinates where the printer can home the Z axis without interfering with the partially-completed print.|*millimeters (mm)| | + | |Specify the X and Y coordinates where the printer can home the Z axis without interfering with the partially-completed print. |
| + | |||
| + | Note: Not shown when [[SETTINGS/Printer/Features/Hardware/Has Hardware Leveling|Has Hardware Leveling]] is enabled as G29 procedures could interfere with a partially-completed print. | ||
| + | |||
| + | Note: Not shown when [[SETTINGS/Printer/Features/Behavior/Home Z Max|Home Z Max]] is enabled as homing up would not interfere with a partially-completed print.|*millimeters (mm)| | ||
=== mm === | === mm === | ||
In this example, the best coordinates on the X and Y axes for the printer to home the Z axis are 185, 190.}} | In this example, the best coordinates on the X and Y axes for the printer to home the Z axis are 185, 190.}} | ||
Revision as of 18:23, 6 December 2016
Function
Specify the X and Y coordinates where the printer can home the Z axis without interfering with the partially-completed print.
Note: Not shown when Has Hardware Leveling is enabled as G29 procedures could interfere with a partially-completed print.
Note: Not shown when Home Z Max is enabled as homing up would not interfere with a partially-completed print.
Parameters
- millimeters (mm)
Example(s)
mm
In this example, the best coordinates on the X and Y axes for the printer to home the Z axis are 185, 190.
