2,552
edits
Changes
→When I restart my printer, values of Steps per mm return to the firmware's default value. How can I change this?
== When I restart my printer, values of Steps per mm return to the firmware's default value. How can I change this? ==
It is likely your printer's firmware does not allow EEPROM to be saved.
In order to apply your settings, you can either update your firmware to allow for EEPROM changes or you can add custom G-Code to the "On Connect G-Code" section in MatterControl. Updating firmware requires a fair bit of effort, so it's probably easier to update the custom G-Code. Here's how:
