Search results

Create the page "Slice Settings/General/Speed/Speed for Non-Print Moves/Travel" on this wiki! See also the search results found.

• CuraEngine Settings
  The slice settings for CuraEngine in MatterControl are divided by three categories: * '''General''': This is where the settings concerning the actual printed part are located. Things like, layer height,
  7 KB (1,045 words) - 12:44, 19 January 2016
• Slic3r Settings
  The slice settings for Slic3r in MatterControl are divided by three categories: * '''General''': This is where the settings concerning the actual printed part are located. Things like, layer height,
  16 KB (2,499 words) - 13:04, 22 December 2016
• Custom G-Code Variables
  ...G-Code]] that will automatically be replaced with the appropriate values. For example: ...ens can be enclosed in either square brackets [] or curly brackets {}, but for compatibility with other slicers square brackets are recommended.
  3 KB (433 words) - 11:32, 28 December 2016