Difference between revisions of "SETTINGS/Printer/Custom G-Code/Start G-Code"
From MatterControl Manual
< SETTINGS | Printer | Custom G-Code
| Line 4: | Line 4: | ||
See also: [[Automatic G-Code]]|*G-Code | See also: [[Automatic G-Code]]|*G-Code | ||
| + | *[[Custom_G-Code_Variables|Custom G-Code variables]] | ||
| − | + | All G-Code must be uppercase to function properly.| | |
=== G-Code === | === G-Code === | ||
Revision as of 09:51, 17 February 2016
Function
G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
See also: Automatic G-Code
Parameters
- G-Code
- Custom G-Code variables
All G-Code must be uppercase to function properly.
Example(s)
G-Code
In this example, the printer will home (G28) at the beginning of the print.
