Difference between revisions of "SETTINGS/Printer/Custom G-Code/Start G-Code"

From MatterControl Manual
Jump to: navigation, search
Line 3: Line 3:
 
|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
 
|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.
  
See also: [[Automatic G-Code]]|*G-Code
+
See also: [[Automatic G-Code]]
 +
 
 +
'''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*[http://reprap.org/wiki/G-code G-Code]
 
*[[Custom_G-Code_Variables|Custom G-Code variables]]
 
*[[Custom_G-Code_Variables|Custom G-Code variables]]
  
Line 14: Line 16:
 
== See Also ==
 
== See Also ==
  
[[Automatic G-Code]]
+
*[[Automatic G-Code]]
 +
*[[G-Code Filtering]]

Revision as of 10:27, 12 October 2016

A screenshot of the Start G-Code setting as seen in MatterControl's SETTINGS pane.

Function

G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.

See also: Automatic G-Code

NOTE: All Custom G-Code is subject to filtering rules.

Parameters

All G-Code must be uppercase to function properly.

Example(s)

G-Code

In this example, the printer will home (G28) at the beginning of the print.

Start G-Code-ss-ex.png

See Also