Difference between revisions of "Category:Slice Settings"

From MatterControl Manual
Jump to: navigation, search
(Created page with "Slice settings are the variables which give the user control over his or her 3D print. Layer height, extruder temperature, and fill density are the most basic of these. Belo...")
 
 
Line 1: Line 1:
 
Slice settings are the variables which give the user control over his or her 3D print. Layer height, extruder temperature, and fill density are the most basic of these.  
 
Slice settings are the variables which give the user control over his or her 3D print. Layer height, extruder temperature, and fill density are the most basic of these.  
  
−
Below you will find the settings available when using MatterSlice as well as links to pages which detail the settings available for using [[CuraEngine Settings|CuraEngine]] or [[Slic3r Settings|Slic3r]].
+
Below you will find the settings available when using MatterSlice, as well as links to pages which detail the settings available for using [[CuraEngine]] or [[Slic3r]].

Latest revision as of 14:42, 15 December 2015

Slice settings are the variables which give the user control over his or her 3D print. Layer height, extruder temperature, and fill density are the most basic of these.

Below you will find the settings available when using MatterSlice, as well as links to pages which detail the settings available for using CuraEngine or Slic3r.

Pages in category "Slice Settings"

The following 200 pages are in this category, out of 203 total.

(previous page) (next page)

C

S

(previous page) (next page)
Retrieved from "http://wiki.mattercontrol.com/index.php?title=Category:Slice_Settings&oldid=455"